Use of hydraulic hose fittings: This connector is suitable for oil, water and air as media sites. Nominal pressure 320kgf / cm2, medium temperature -30 ℃ 200 ℃ Material: Carbon Features: 1) unique design allows the ends firmly clasp yin and yang together valve automatically opens at both ends, in the nominal range of fluid remains smooth. 2) Disconnect both ends of the spool automatically shut down to prevent fluid spill. 3) key parts quenching, greatly improving the pressure resistance and abrasion resistance. 4) standard seal material NBR wire braided hydraulic hose fittings, high temperature Viton 5) This product complies with ISO5675 standards 6) can also be customized according to customer requirements and processing. Features: card sets of pipe joints consists of three parts: the connector body, card sets, nut. When the card is inserted into the sleeve and the sleeve nut on the pipe joint body, when tightening the nut and ferrule connector body outside of the front taper fit stainless steel hydraulic hose fitting, seamless steel biting edge evenly to form an effective seal. Assembled pipe joints card sets, 1, saw a suitable length of seamless steel tubes, burr removal port. Pipe end to be perpendicular to the axis, the angle tolerance of not more than 0.5 degrees. If you need to bend the steel pipe, the pipe end to the curved portion of the length of the line segment can not be less than three times the length of the nut. 2, the nut and a condom on seamless steel tubes. Note the direction of the nut and ferrule hydraulic hose fittings, not installed backwards. 3, in the pre-assembled connector body and cards put on greased thread, insert the pipe joint body, (pipe must be inserted in the end) Tighten the nuts by hand. 4. Tighten the nut until the ferrule stuck pipe, the turning point in the tightening torque can be increased by feel (pressure points). 5, the pressure point is reached, and then tighten the nut 1/2 turn. 6, the pre-assembled connector body removed, embedded in the inspection card sets edge side, visible protrusions must fill the space with the front of the card sets. Card sets can be slightly rotated, but can not move axially. 7, the final installation, screw Lubricate the actual installation of the connector body, tighten the compression nut and match to increase the perceived tightening force so far, and then tighten 1/2 turn installed. All pipe joints card sets are repeatedly reloading high pressure hydraulic hose fittings, but to ensure that no damage and clean the parts. 1, the pipe inserted into the fitting body until the body cone sleeve joints snapping, hand tighten the nut. 2. Tighten the nut with a wrench until the tightening torque increases sharply, then tighten 1/4 to 1/2 turn to. Pipe assembly can be removed to check whether it is required: a steel ferrule ends should have even a slight bump. Card sets can not slide back and forth, but allow a slight rotation. Hydraulic hose fittings hydraulic hose fittings manufacturers _ _ Bo-Rubber (certified merchants) provided by Bo-Rubber Products Co., Ltd. Hengshui. Hengshui Bo-Rubber Products Co., Ltd. (www.jxboguang.com/) is specialized in the "high-voltage wire braided hose, spiral hose and assembly, cloth, fiber weave, fiber curtain" of the enterprise, the company is adhering to the "integrity management, intentions of service "concept, to provide you with the highest quality products and services. Welcome to inquire! Contact: Wang Yang.